Telit Wireless Solutions LE910C series - AT#BBNDLIST - BLE Bond List

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1883 of 1904 2022-03-04
Not Subject to NDA
3.35.26. AT#BBNDLIST - BLE Bond List
This command is used to display information about the BLE bonded devices.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BBNDLIST
Set command is used to display information about the bonded devices.
Each entry in the bonded-device list contains the Bluetooth address and
Bluetooth address type (t2-BLE public Address, t3-BLE Random
address).
AT#BBNDLIST?
Read command returns the values of parameters in the format:
#BBNDLIST: <BD Address>,<BD Address Type>
<BD Address> - It specifies the remote Bluetooth address.
The supported parameter value range is 1-48.
<BD Address Type> - It specifies the remote Bluetooth address type.
The supported parameter value range is 0-2.
Where,
t2- public address
t3- random address
Always printing t2.
AT#BBNDLIST=?
Test command reports supported range of values for all parameters.