Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 493 of 1904 2022-03-04
Not Subject to NDA
3.4.42. AT#ALLOWHAC - Allow Network Access with high Access Class only
This command is enabled or disabled to control High-Access-class-only modules to
camp onto the network.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ALLOWHAC=<mode>
Set command enables or disables to control High-Access-class-only
modules to camp onto the network.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
Defines to control Camp on to the network
without Low-Access-Classes
Values:
0
:
Disable to camp on to the network without Low-
Access-Classes
1
:
Enable to camp on to the network without Low-
Access-Classes
This setting value is saved in NVM.
It is recommended performing a reboot the module after every
#ALLOWHAC setting.
AT#ALLOWHAC?
Read command returns the current value of parameter <mode>.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English