Telit Wireless Solutions LE910C series - Bluetooth Low Energy; AT#BI - BLE Initialize;De-Initialize

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1830 of 1904 2022-03-04
Not Subject to NDA
Bluetooth Low Energy
3.35.1. AT#BI - BLE Initialize/De-initialize
This command is used to initialize/de-initialize the BLE stack.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#BI=<START>[,<Interface Id>]
Parameters:
Name
Type
Default
Description
<START>
integer
N/A
It specifies the initialization/de-
initialization of the BLE stack.
Values:
0
:
De-initializes BLE stack
1
:
Initializes BLE stack
<Interface
Id>
integer
0
It specifies the UART port to be used for
BLE interface
Values:
0
:
Select Aux UART port for BLE interface
1
:
Select Main UART port for BLE interface
Before executing other BLE AT commands, this command must be
called first to start the initialization process.
If AUX port is used for BT interface, then below commands must be
issued.