Telit Wireless Solutions LE910C series - AT#CALLDISA - Call Disable Setting

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 348 of 1904 2022-03-04
Not Subject to NDA
3.2.5.11. AT#CALLDISA - Call Disable Setting
This command used to control the Disable Call Type and SMS only registration.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#CALLDISA=<disable_type>[,<sms_only>]
Set command sets the Disable Call Type and SMS only registration
Parameters:
Name
Type
Default
Description
<disable_type>
integer
0
Disable Type. It is used to
enable/disable the Voice Call
function
Values:
0
:
Enable Voice Call
1
:
Disable Voice Call
2
:
Disable Voice Call (same as 1)
<sms_only>
integer
0
SMS only. It is used to on/off the
SMS only parameter.
Values:
0
:
None
1
:
SMS only registration
Settings are affected after rebooting
If 1st parameter is set, the outgoing calls are not possible and the
incoming calls are rejected on the modem.