LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 347 of 1904 2022-03-04
<mode>=2
Voice call and data call, the following custom result codes are
received, monitoring step by step the call status:
DIALING (MO in progress)
RINGING (remote ring)
CONNECTED (remote call accepted)
RELEASED (after ATH)
DISCONNECTED (remote hang-up).
Any character typed before the CONNECTED message aborts the
call.
In case a BUSY tone is received and at the same time ATX0 is
enabled ATD will return NO CARRIER instead of DISCONNECTED.
The setting is saved in NVM and available on following reboot.
AT#DIALMODE?
Read command returns current ATD dialling mode in the format:
#DIALMODE: <mode>
AT#DIALMODE=?
Test command returns the supported range of values for parameter
<mode>.
To Next Page
Loading...
