Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1582 of 1904 2022-03-04
Not Subject to NDA
3.25.7. AT#DWCONN - Connect to IoT Portal
This command connects/disconnects to the IoT Portal.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#DWCONN=<connect>
Set command connects/disconnects to the M2M Service.
Parameter:
Name
Type
Default
Description
<connect>
integer
0
flag to connect/disconnect to the M2M
Service
Values:
0
:
disconnect
1
:
connect
AT#DWCONN=1 performs the socket connection and the MQTT
connection. AT#DWCONN=0 performs the socket disconnection.
the PDP Context used for the network connection is the first
(<cid>=1 has to be previously defined with AT+CGDCONT command
and activated with AT#SGACT command)
if the secure mode connection has been enabled, it cannot be used
contemporarily to any command starting an SSL connection
(including SSL sockets, FTPS, secure SMTP and HTPS).
AT#DWCONN?

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English