Telit Wireless Solutions LE910C series - AT#SKIPGCF - SKIPGCF Mode Enable; Disable for Thermal Test

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1192 of 1904 2022-03-04
Not Subject to NDA
3.15.34. AT#SKIPGCF - SKIPGCF mode enable / disable for thermal test
This command allows to set for skip the GCF mode when thermal test with Call-box and
GCF SIM.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SKIPGCF=<mode>
Set command enables/disables to skip GCF mode for thermal test with
Call-box and GCF SIM.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
enable/disable the skip GCF mode
Values:
0
:
Disable the skip GCF mode. (Factory Default)
1
:
Enable the skip GCF mode.
Qualcomm described that Thermal management is active only
when using a non-GCF SIM, i.e., a SIM that is not programmed with
MCC-MNC(1-1).
The values set by command stored in NVM and this value be
applied after rebooting the modem.
After setting the #SKIPGCF=1, Need UE twice reboot for thermal
algorithm proper operation with GCF programmed SIM.
AT#SKIPGCF?