Telit Wireless Solutions LE910C series - Packet Domain; AT#SWITCHATTPROF - Enable;Disable Special LTE Attach Policy Based on; Operator Requirements

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 769 of 1904 2022-03-04
Not Subject to NDA
Packet Domain
3.9.1. AT#SWITCHATTPROF - Enable/Disable special LTE attach policy based on
operator requirements
Enable/Disable special LTE attach policy based on operator requirements
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SWITCHATTPROF=<mode>
Set command to enable or disable special LTE attach policy based on
operator requirements
Parameter:
Name
Type
Default
Description
<mode>
integer
N/A
enable or disable special LTE attach policy
Values:
0
:
Disable
1
:
Enable
Manual reboot is required after changing.
Predefined default value is dependent according to operator
requirements.
Predefined default value that operator requested should not
recommended to change.
This command is required when testing such as GCF/PTCRB RRM
(Radio Resource Management) without setting the requirements of
operators in the equipment.