Telit Wireless Solutions LE910C series - AT\R - Ring (RI) Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 328 of 1904 2022-03-04
Not Subject to NDA
3.2.4.24. AT\R - Ring (RI) Control
This command allows the user to control the RING output pin behaviour.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT\R[<n>]
Set command controls the RING output pin behaviour.
Parameter:
Name
Type
Default
Description
<n>
integer
1
RING pin behaviour
Values:
0
:
RING on during ringing and further connection
1
:
RING on during ringing
2
:
RING follows the ring signal
If the parameter is omitted, the command has the same behaviour
of AT\R0.
To check the ring option status use the &V command.