Telit Wireless Solutions LE910C series - AT#KIPR - Keep DTE Interface Rate

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 317 of 1904 2022-03-04
Not Subject to NDA
3.2.4.19. AT#KIPR - Keep DTE Interface Rate
This command enables/disables to keep the current DTE speed permanently.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#KIPR=<enable>
Set command enables/disables to keep the current DTE speed
permanently. If enabled, the current DTE speed configured by +IPR won't
be changed back to default value specified by manufacturer even if &F or
base section value of the specified by user profile even if Z.
Parameter:
Name
Type
Default
Description
<enable>
integer
0
enables/disables to keep the current DTE
speed permanently
Values:
0
:
disable
1
:
enable to keep the current DTE speed
Setting value is saved in the NVM.
This behavior is valid only for UART port.
AT#KIPR?
Read command returns the current value of #KIPR parameter.
AT#KIPR?