Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 111 of 1904 2022-03-04
Not Subject to NDA
General Control and Config
3.2.1. Command Line Prefixes
3.2.1.1. AT - Starting a Command Line
AT is the prefix used to start a command line.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT
The prefix AT is a two-character abbreviation ("ATtention"), always used
to start a command line to be sent from TE to TA, with the only exception
of AT#/ prefix. As a command, it can be issued just to test if the device is
responding to AT commands.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English