Telit Wireless Solutions LE910C series - AT+CGSCONTRDP - Secondary PDP Context Read Dynamic Parameters

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 853 of 1904 2022-03-04
Not Subject to NDA
3.9.32. AT+CGSCONTRDP - Secondary PDP Context Read Dynamic Parameters
This command returns parameters for a given <cid>.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CGSCONTRDP[=<cid>]
The execution command returns <p_cid> and <bearer_id> parameters for
a given <cid>. If the context cannot be found an ERROR response is
returned. If the parameter <cid> is omitted, the <cid>, <p_cid> and
<bearer_id> are returned for all established PDP contexts. Format of the
returned message:
+CGSCONTRDP:<cid>,<p_cid>,<bearer_id>[<CR><LF>
+CGSCONTRDP:<cid>,<p_cid>,<bearer_id>[...]]
Parameter:
Name
Type
Default
Description
<cid>
integer
-
specifies a particular PDP context or Traffic
Flows definition. The parameter is local to the
TE-MT interface and is used in other PDP
context-related commands.
Additional info:
Here is the list of the parameters meanings returned by the
+CGSCONTRDP command.
Name
Type
Default
Description
<p_cid>
integer
-
specifies a particular PDP
context definition or default EPS
context Identifier which has been
specified by use of the