Telit Wireless Solutions LE910C series - AT+CIND - Indicator Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 150 of 1904 2022-03-04
Not Subject to NDA
3.2.2.30. AT+CIND - Indicator Control
This command is used to control the registration state of modem indicators.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT+CIND=[<state>[,<state[,...]]]
Set command is used to control the registration state of ME indicators, in
order to automatically send the +CIEV URC, whenever the value of the
associated indicator changes. The supported indicators (<descr>) and their
order appear from test command AT+CIND=?
Parameter:
Name
Type
Default
Description
<state>
integer
1
registration
state
Values:
0
:
the indicator is deregistered; there's no unsolicited
result code (+CIEV URC) automatically sent by the
modem to the application, whenever the value of the
associated indicator changes; the value can be directly
queried with +CIND?
1
:
the indicator is registered: an unsolicited result code
(+CIEV URC) is automatically sent by the modem to the
application, whenever the value of the associated
indicator changes; it is still possible to query the value
through AT+CIND?