Telit Wireless Solutions LE910C series - AT#WLANCLOCK - Set SDIO Clock of the WLAN

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 750 of 1904 2022-03-04
Not Subject to NDA
3.8.23. AT#WLANCLOCK - Set SDIO clock of the WLAN
This command is used to set the SDIO clock of the WLAN interface
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#WLANCLOCK=<clock>
Set command for configure SDIO clock of the WLAN.
Parameter:
Name
Type
Default
Description
<clock>
integer
6
parameter to specify the SDIO clock
Values:
1
:
400khz
2
:
20Mhz
3
:
25Mhz
4
:
50Mhz
5
:
100Mhz
6
:
200Mhz
In order to apply new configuration, the WLAN must be restarted.
This value stored into module storage and keep maintain changed
value by customer even if reboot or FW update
AT#WLANCLOCK?
Read currently configured SDIO clock of the WLAN as below format