Telit Wireless Solutions LE910C series - AT&F - Set to Factory-Defined Configuration

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 115 of 1904 2022-03-04
Not Subject to NDA
3.2.2.2. AT&F - Set to Factory-Defined Configuration
Set configuration parameters to default values.
ITU-T Recommendation V.25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT&F[<value>]
Execution command sets the configuration parameters to default values
specified by manufacturer; it takes in consideration hardware
configuration switches and other manufacturer-defined criteria.
Parameter:
Name
Type
Default
Description
<value>
integer
0
parameters to reset
Values:
0
:
only the factory profile base section parameters are
considered
1
:
either the factory profile base section and the
extended section are considered (full factory profile)
If parameter <value> is omitted, the command has the same
behavior as AT&F0.