Telit Wireless Solutions LE910C series - AT#TRACE - Enable;Disable Trace

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 184 of 1904 2022-03-04
Not Subject to NDA
3.2.2.46. AT#TRACE - Enable/Disable Trace
The command selects which trace outputs you want to display through the debugging
tool.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#TRACE=[<mode>[,<configurationString>]]
Parameters:
Name
Type
Default
Description
<mode>
integer
N/A
switches all trace outputs ON
or OFF. If parameter <mode>
is no entered in
the command, the following
<configurationString> will be
used.
Values:
0
:
sets all trace outputs OFF,
<configuration String> will be ignored
1
:
sets all trace outputs ON,
<configurationString> will be ignored
<configurationString>
string
-
enables/disables a set of
trace outputs, its syntax is
shown in the Additional info
section.
Additional info:
The syntax of the <configurationString> is:
["<unit>=<umode>[,<unit>=<umode>[,...]]"]
Here are the meanings and values of the string parameters.