Telit Wireless Solutions LE910C series - AT+COLP - Connected Line Identification Presentation

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 384 of 1904 2022-03-04
Not Subject to NDA
3.4.7. AT+COLP - Connected Line Identification Presentation
This command enables/disables the presentation of the COL at the TE.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Specific profile
No
-
2
AT+COLP=[<n>]
Set command enables/disables the presentation of the COL at the TE.
When enabled (and called subscriber allows), the following intermediate
result code is returned from TA to TE before any +CR or ITU T
Recommendation V.250 responses:
+COLP: <number>,<type>[,<subaddr>,<satype>[,<alpha>]]
Parameter:
Name
Type
Default
Description
<n>
integer
0
enable/disable COL indication
Values:
0
:
disable COL indication
1
:
enable COL indication
Additional info:
This command refers to the GSM/UMTS supplementary service
COLP (Connected Line Identification Presentation) that enables a
calling subscriber to get the connected line identity (COL) of the
called party after setting up a mobile originated call.