Telit Wireless Solutions LE910C series - AT#RNDIS - Remote Network Driver Interface Specification Setup

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1203 of 1904 2022-03-04
Not Subject to NDA
3.16.1.4. AT#RNDIS - Remote Network Driver Interface Specification setup
This command sets up Remote Network Driver Interface Specification(RNDIS) session.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#RNDIS=<Cid>,<Did>
This command sets up a Remote Network Driver Interface Specification
(RNDIS) session.
Parameters:
Name
Type
Default
Description
<Cid>
integer
-
Valid PDP ID
<Did>
integer
-
Device id, currently limited to 0(only one
device)
This command activates a PDP context, so all necessary setup has
to be done before it (registration, APN).
If target PDP is not connected to WWAN , return ERROR
If a PDP context is already established , return OK
If user configuration is not in proper format, return ERROR
- ex) ip: 192.168.225.2 , nm: 255.255.255.0 gw: 1.1.111.1
If user try to set different network configuration comparing to
current one using AT#RNDISC first. Then upon executing #RNDIS
command, the UART console will be disconnected as USB driver
will be reloaded to make host device broadcast DHCP.