Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1080 of 1904 2022-03-04
Not Subject to NDA
Power Down
3.14.1. AT#REBOOT - Module Reboot
Immediate module reboot.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#REBOOT
Execution command reboots immediately the unit.
It can be used to reboot the system after a remote update of the script in
order to have the new one running.
If #REBOOT follows an AT command that stores some
parameters in NVM, it is recommended to insert a delay of at
least 5 seconds before to issue #REBOOT, to permit the complete
NVM storing.
#REBOOT is an obsolete AT command; please refer to #ENHRST
to perform a module reboot.
URC messages occurred during the shutdown procedure of
#REBOOT may not be shown.
AT#REBOOT=?
Test command returns OK result code.
•
Reboot the module
AT#REBOOT
OK
(the module reboots)

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English