Telit Wireless Solutions LE910C series - AT#ECONLY - Set Ecall Only Mode

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1076 of 1904 2022-03-04
Not Subject to NDA
3.13.9. AT#ECONLY - Set eCall Only Mode
This command enables the eCall Only mode of operation.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ECONLY=<mode>
Set command enables/disables the eCall Only mode of operation
Parameter:
Name
Type
Default
Description
<mode>
integer
0
eCall Only mode of operation
Values:
0
:
disable eCall Only mode, normal mode
1
:
enable eCall Only mode if eCall only subscription is
available
2
:
enable eCall Only mode even if eCall only subscription
is not available
The value set by command is directly stored in NVM.
The <mode> of "1 - enable eCall Only mode if eCall only
subscription is available" is available at the next switch-on.
AT#ECONLY?
Read command reports the currently selected <mode> and <status> in the
format:
#ECONLY: <mode>,<status>