Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 858 of 1904 2022-03-04
Not Subject to NDA
3.9.34. AT#SINGLEAPNSWITCH - set APN param change
This command sets APN param change.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SINGLEAPNSWITCH=<mode>
If it is enabled and an APN network identifier or APN-related parameter is
updated, Modem can re-activate PDN context with changed APN if there
are no application working on the activated PDN context and APN name is
changed. If the PDN context is for LTE attach, UE will attempt to reattach
with changed APN. In other systems, this command works as if it is
disabled.
If it is disabled, the changed APN will go into effect at the moment when
the PDN context is deactivated and then re-activated. Power recycling is
one of operations that will have new APN activated.
Parameter:
Name
Type
Default
Description
<mode>
integer
N/A
Set enable or disable
Values:
0
:
Disable
1
:
Enable
Value set by command is directly stored in NVM and available at
next reboot.
default value is depended on network vendor. VZW/TELSTRA is 1.
no application means that user did not use #SGACT=1,1.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English