Telit Wireless Solutions LE910C series - AT#WLANMACMODE - Enable;Disable MAC Address Filtering

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 756 of 1904 2022-03-04
Not Subject to NDA
3.8.26. AT#WLANMACMODE - Enable/disable MAC address filtering
This command is used to enable/disable the MAC address filter and is Relevant for AP
mode only.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#WLANMACMODE=<mode>
Set command allows to enable/disable the MAC address filter. Relevant
for AP mode only.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
MAC address filter Mode
Values:
0
:
Accept unless in deny list (default)
1
:
Deny unless in accept list
AT#WLANMACMODE?
Read command returns the current mode in the format:
#WLANMACMODE : <num>
Example:
at#wlanmacmode?
#WLANMACMODE: 1
AT#WLANMACMODE=?