Telit Wireless Solutions LE910C series - AT\Q - Standard Flow Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 293 of 1904 2022-03-04
Not Subject to NDA
3.2.4.7. AT\Q - Standard Flow Control
This command controls the RS232 flow control behavior.
ITU-T Recommendation V25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT\Q[<n>]
Set command controls the RS232 flow control behavior.
Parameter:
Name
Type
Default
Description
<n>
integer
3
RS232 flow control behavior
Values:
0
:
no flow control
2
:
hardware mono-directional flow control (only CTS
active)
3
:
hardware bi-directional flow control (both RTS/CTS
active)
If parameter is omitted, the command has the same behaviour as
AT\Q0.
Hardware flow control (AT\Q3) is not active in command mode. To
active this setting in command mode, use AT#CLFO=1.
AT\Q's settings are functionally a subset of AT&K's ones.