Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1144 of 1904 2022-03-04
Not Subject to NDA
3.15.21. AT#SPIEN - Enable SPI Configuration
This command used to enable/disable SPI configuration.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#SPIEN=<mode>
Set command enables SPI configuration.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
mode
Values:
0
:
Disable SPI configuration
1
:
Enable SPI configuration
Manual reboot is required after changing.
Change value is stored on module and applied after next power
cycle.
If <mode> is 0, interface is configured as UART 2 Port (See
"Hardware User Guide section 3.1") and setting values configured
by #SPICFG are initialized.
This command is synchronized with variant 17 of #PORTCFG in
LE910C1-EUX/SAX/SVX and LE910Cx-WWX product. If SPI is
enabled, the request value of #PORTCFG is changed to 17 at the
same time.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English