Telit Wireless Solutions LE910C series - AT$GPSELNA - GNSS External LNA Support

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1712 of 1904 2022-03-04
Not Subject to NDA
3.28.2.2. AT$GPSELNA - GNSS External LNA support
This command configures to support the GNSS external LNA.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT$GPSELNA=<mode>
Set command is used to enable/disable GNSS External LNA Support.
Parameter:
Name
Type
Default
Description
<mode>
integer
1
GNSS External LNA Option
Values:
0
:
Not support GNSS External LNA
1
:
Support GNSS External LNA
If <mode> is 0, GNSS RF receiver is high gain mode. If <mode> is 1,
GNSS RF receiver is low gain mode.
If the GNSS external LNA isn't supported on H/W, please never set
<mode>=1 (Support GNSS External LNA).
This setting is dependent on H/W Design.
AT$GPSELNA?
Read command returns the currently setting, in the format.
$GPSELNA: <mode>