Telit Wireless Solutions LE910C series - AT#ALARMPIN - Alarm Pin Configuration

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1122 of 1904 2022-03-04
Not Subject to NDA
3.15.11. AT#ALARMPIN - Alarm Pin Configuration
This command allows to configure the ALARM Pin.
[1] Hardware User's Guide of the used module
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ALARMPIN=<pin>
Set command allows to set a GPIO pin as ALARM pin.
Configuring a GPIO pin as ALARM pin is equivalent to setting it up with the
ALT2 alternate function. Therefore, a GPIO pin can be configured as
ALARM pin also through the #GPIO command. To have information on
GPIO pins refer to document [1].
Parameter:
Name
Type
Default
Description
<pin>
integer
0
GPIO pin number.
Max is the number of GPIO pins provided by
the module. For information on the available
GPIO pins use the test command.
Values:
0
:
no ALARM pin set
1÷Max
:
GPIO pin number
AT#ALARMPIN?
Read command returns the current value of the parameter <pin> in the
format: