Telit Wireless Solutions LE910C series - AT#NCIH - no CARRIER Indication Handling

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 109 of 1904 2022-03-04
Not Subject to NDA
3.1.21. AT#NCIH - NO CARRIER Indication Handling
This command purpose is to Enable\Disable the NO CARRIER indication message when
an incoming call is dropped.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT#NCIH=<enable>
Set command enables/disables the sending of a NO CARRIER indication
due to incoming ringing call dropped by the caller before the answer takes
place.
Parameter:
Name
Type
Default
Description
<enable>
integer
0
Enable/Disable value for NO CARRIER
indication sending.
Values:
0
:
disabled
1
:
enabled
AT#NCIH?
Read command reports whether the feature is currently enabled or not, in
the format:
#NCIH: <enable>
AT#NCIH=?
Test command returns the supported range of values for parameter
<enable>.