Telit Wireless Solutions LE910C series - AT#FRATTRIGGER - Configure FRAT Trigger Parameter

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 239 of 1904 2022-03-04
Not Subject to NDA
3.2.2.73. AT#FRATTRIGGER - Configure FRAT Trigger parameter
This command sets the parameter needed to trigger the FRAT.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#FRATTRIGGER=<gpio_pin>[,<trigger_value>]
This command sets the parameter needed to trigger the FRAT.
Parameters:
Name
Type
Default
Description
<gpio_pin>
integer
0
Numeric parameter that selects
how to get the frat_trigger value.
Values:
0
:
gets the frat_trigger value from
<trigger_value>.
1÷10
:
gets the frat_trigger value from TGPIO
#<gpio_pin>.
<trigger_value>
integer
1
numeric parameter which selected
how to trigger the FRAT.
Values:
0
:
slow trigger
1
:
fast trigger
<gpio_pin> is attached to ALT8 func (see AT#GPIO).
<gpio_pin> is save to NVM.