Telit Wireless Solutions LE910C series - Page 240

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 240 of 1904 2022-03-04
Not Subject to NDA
<gpio_pin> default is 0.
<trigger_value> default is 1.
<trigger_value> will reset to default in each power up.
It can support only AT&T specific module.
AT#FRATTRIGGER?
Read command returns the current settings for the frat trigger:
#FRATTRIGGER: <gpio_pin>,<trigger_value>
AT#FRATTRIGGER=?
Test command returns the supported range of parameters
<gpio_pin>,<trigger_value>