Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1546 of 1904 2022-03-04
Not Subject to NDA
3.23.12. AT#TCPATRUNL - Enables TCP AT Run Service in Listen (Server) Mode
This command enables/disables the TCP AT RUN service in server mode. When this
service is enabled, the module tries to put itself in TCP listen state.
Telit Running AT Commands Remotely Application Note, 80000NT10029a
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#TCPATRUNL=<mod>
Set command enables/disables the TCP AT RUN service in server mode.
When this service is enabled, the module tries to put itself in TCP listen
state.
Parameter:
Name
Type
Default
Description
<mod>
integer
0
enable/disable TCP AT RUN service in server
mode.
Values:
0
:
service disabled
1
:
service enabled
to start automatically the service when the module is powered-on,
the automatic PDP context activation has to be set (see
AT#SGACTCFG command).
while the TCP Run AT service executes a command that takes long
time to get the response, a new command will be pending until the
module has finished sending all of its response result code.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English