Telit Wireless Solutions LE910C series - AT&P - Default Reset Full Profile Designation

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 118 of 1904 2022-03-04
Not Subject to NDA
3.2.2.5. AT&P - Default Reset Full Profile Designation
Define which full profile is loaded at startup.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT&P[<n>]
Execution command defines which full profile will be loaded at startup.
Parameter:
Name
Type
Default
Description
<n>
integer
0
full profile will be loaded on
startup.
Value:
0,1
:
profile number: the wireless module can store 2 full
configurations (see command &W).
Differently from command Z<n>, which loads just once the desired
profile, the one chosen through command &P will be loaded at
every startup.
If parameter is omitted, the command has the same behavior as
AT&P0