Telit Wireless Solutions LE910C series - AT#CSURVW - Network Survey with Only WCDMA

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1491 of 1904 2022-03-04
Not Subject to NDA
3.22.7. AT#CSURVW - Network Survey with only WCDMA
The command allows to perform a network survey through band channels with only
WCDMA.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
Yes
180 s
2
AT#CSURVW[=[<s>,<e>]]
Execution command allows to perform a quick survey through channels
belonging to the band selected by last #BND command issue, starting
from channel <s> to channel <e>. Issuing AT#CSURVW<CR>, a full band
scan is performed.
After issuing the command the device responds with the string:
Network survey started...
and, after a while, a list of information, one for each received carrier, is
reported.
The #CSURVW output ends in two ways, depending on the last
#CSURVF setting:
if #CSURVF=0 or #CSURVF=1
The output ends with the string:
Network survey ended
if #CSURVF=2
the output ends with the string:
Network survey ended (Carrier: <NoARFCN> BCCh: <NoBCCh>)
Where:
<NoARFCN> - number of scanned frequencies
<NoBCCH> - number of found BCCh
Parameters: