Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1088 of 1904 2022-03-04
Not Subject to NDA
3.14.5. AT#FASTSHDN - Fast Shutdown Configuration
This command can be used as a set command to configure a GPIO pin performing a fast
shutdown when on it is forced a High to Low level transition. Or can be used as an
execute command to force immediately a fast shutdown.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#FASTSHDN[=<enable>[,<pin>]]
Set command configure fast power down.
Parameters:
Name
Type
Default
Description
<enable>
integer
0
enable/disable the fast shutdown
execution via a GPIO pin.
Values:
0
:
disabled
1
:
enabled
<pin>
integer
-
GPIO number used for fast power down
event monitoring. Valid range is "any input
pin" (see "Hardware User's Guide").
This parameter used when <enable> is 1.
Additional info:
Module enter power off autonomously if fast power down is enabled
and event monitoring GPIO goes to low after modem boot done.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English