Telit Wireless Solutions LE910C series - AT#WLANPC - Change the Channel Number and the Wlan Protocol

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 767 of 1904 2022-03-04
Not Subject to NDA
3.8.32. AT#WLANPC - Change the channel number and the wlan protocol
This command is used to change the AP channel number and the protocol.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#WLANPC=<mode>,<num>
Set command allows to change the AP channel number. Relevant for AP
mode only.
Parameters:
Name
Type
Default
Description
<mode>
integer
2
Protocol type
Values:
0
:
'b-only' (2.4 GHz)
1
:
'b/g' (2.4 GHz)
2
:
'b/g/n' (2.4 GHz)
3
:
'a/n' (5 GHz)
4
:
'a/n/ac' (5 GHz)
<num>
integer
-
Channel number. default value is 6
The channel can be selected automatically at run time by setting
channel=0.
AT#WLANPC?
Read command returns the current channel number and protocol in the
format: