Telit Wireless Solutions LE910C series - Jamming Detection and Report; AT#JDRENH2 - Enhanced Jamming Detection and Report

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 355 of 1904 2022-03-04
Not Subject to NDA
Jamming Detection and Report
3.3.1. AT#JDRENH2 - Enhanced Jamming Detection and Report
This command enables/disable jamming detection and reports the relative result to the
user.
[1] Hardware User's Guide of the used module
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#JDRENH2=<mode>[,<sat2G>,<unused>,<carrNum2G>,<pRxLevT2G>,<unused>,
<unused>,<unused>[,<P_RSSI_T4G>[,<P_RSRQ_T4G>[,<unused>[,<urcDump>]]]]]
The set command performs the following activities:
- enables/disables the detection of the presence of jamming in the module
coverage.
- selects one of the following two reports mode or both: on dedicated GPIO, by
means of the URC, or GPIO + URC
Parameters:
Name
Type
Default
Description
<mode>
integer
0
enable/disable jamming detection
and select reporting mode
Values:
0
:
disable jamming detection