Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 117 of 1904 2022-03-04
Not Subject to NDA
3.2.2.4. AT&Y - Default Reset Basic Profile Designation
Define the basic profile is loaded on startup.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT&Y[<n>]
Execution command defines the basic profile that will be loaded on
startup.
Parameter:
Name
Type
Default
Description
<n>
integer
0
basic profile that will be loaded on
startup.
Value:
0,1
:
profile number: the wireless module can store 2
complete configurations (see command &W).
Differently from command Z<n>, which loads just once the desired
profile, the one chosen through command &Y will be loaded on
every startup.
If parameter is omitted the command has the same behavior as
AT&Y0.
In LE910Cx, AT&Y is not supported.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English