Telit Wireless Solutions LE910C series - AT#ETHSTATUS - Link Status of Ethernet

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1097 of 1904 2022-03-04
Not Subject to NDA
3.15.5. AT#ETHSTATUS - Link status of Ethernet
This command is used to enable/disable the presentation of ethernet link status URC.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
Yes
-
2
AT#ETHSTATUS=[<urcmode>]
Parameter:
Name
Type
Default
Description
<urcmode>
integer
0
URC mode
Values:
0
:
It disables the presentation of ethernet link status
URC
1
:
It enables the presentation of ethernet link status
URC;
Additional info:
If the <urcmode> is enabled, the user is nofied by the following URC:
#ETHSTATUS: <status>
If ethernet cable is connected and ethernet link status is
established, the value of <status> is 1
If ethernet cable is disconnected, the value of <status> is 0
This command is possible to detect ethernet link status when
ethernet interface is enabled by #ETHEN command.