Telit Wireless Solutions LE910C series - AT#WLANCMIFSEL - Select between Concurrent Mode Interfaces

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 747 of 1904 2022-03-04
Not Subject to NDA
3.8.21. AT#WLANCMIFSEL - Select between Concurrent mode interfaces
This command is used to switch between the two concurrent WLAN interfaces.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#WLANCMIFSEL=<IFnum>
Set command allows you to select the requested type of WLAN interface,
to apply further AT commands.
Parameter:
Name
Type
Default
Description
<IFnum>
integer
0
Current Interface
Values:
0
:
First Interface
1
:
Second Interface
This command is applicable only to the Concurrent mode
supported in AT#WLANMODE=<3>.
AT#WLANCMIFSEL?
Read command returns the currently selected concurrent mode WLAN
interface status in the format:
#WLANCMIFSEL: <IFnum>
Where:
<IFnum>
0 - First interface (default)
1 - Second interface