Telit Wireless Solutions LE910C series - AT#FWSWITCH - Set Active Firmware Image

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 223 of 1904 2022-03-04
Not Subject to NDA
3.2.2.66. AT#FWSWITCH - Set Active Firmware Image
Set command allows enabling one configuration of the firmware configurations
embedded on product.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#FWSWITCH=<net_conf>[,<storage_conf>[,<restore_user_conf>]]
Set command allows enabling one configuration of the firmware
configurations embedded on product.
Parameters:
Name
Type
Default
Description
<net_conf>
integer
-
Network config to be enabled
Test command show the
supported <net_conf> values
range.
Please, refer to the table in
Additional info section where
is also described <net_conf>
list and the default values
depend on the products
<storage_conf>
integer
0
Selects storage configuration.
It's a dummy parameter for
the backward compatibility
with the legacy products.
Values:
0
:
save the <configNumber> value in RAM
1
:
save the <configNumber> value in NVM