Telit Wireless Solutions LE910C series - AT$GPSRST - Restore Default GNSS Parameters

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1714 of 1904 2022-03-04
Not Subject to NDA
3.28.2.3. AT$GPSRST - Restore Default GNSS Parameters
This command resets the GNSS parameters to "Factory Default" configuration.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT$GPSRST
Execution command resets the GNSS parameters to "Factory Default"
configuration and stores them in the NVM of the device.
AT$GPSRST=?
Test command returns the OK result code.
The restored parameters are those of:
$GPSP, $GPSR, $GPSNMUN, $GPSNMUNEX, $GPSQOS, $GPSSLSR,
$GPSSTOP and $GPSAT commands. (see their default value at each
command description)
If the GPS controller is powered up (see $GPSP), the GNSS
controller is powered down because the GNSS parameters should be
reset with "Factory Default".
AT$GPSRST
OK