Telit Wireless Solutions LE910C series - AT+CMGC - Send SMS Command

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 647 of 1904 2022-03-04
Not Subject to NDA
3.6.17. AT+CMGC - Send SMS Command
The command is related to sending SMS command.
3GPP TS 27.005
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CMGC
Execution command sends command message from a TE to the network
(SMS-COMMAND). It can have two syntax formats according to the SMS
format: PDU or Text mode (see +CMGF command). If SMS command is
successfully sent to the network, the result is shown with the following
URC:
in PDU mode:
+CMGC: <mr>[,<ackpdu>]
in text mode:
+CMGC: <mr>[,<scts>]
Additional info:
In PDU mode, the +CMGC command has the following syntax:
AT+CMGC=<length>
After command line is terminated with <CR>, the module responds
sending a four-character sequence prompt: