Telit Wireless Solutions LE910C series - Page 648

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 648 of 1904 2022-03-04
Not Subject to NDA
<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)
and waits for the specified number of bytes. the PDU shall be
hexadecimal format (each octet of the PDU is given as two IRA
character long hexadecimal number) and given in one line.
To send the message issue Ctrl-Z char (0x1A hex). To exit without
sending the message issue ESC char (0x1B hex).
Name
Type
Default
Description
<length>
integer
-
length of the actual TP data unit in
octets. (Excluding the SMSC
address octets).
Message header and contents in PDU mode format. See
description in Table:
Reference
Description
Length
<SCA>
Service Center address:
1 BYTE: length (number of followed
octets). Mandatory 1 BYTE: <tosca> -
value between 128-255
1, 3-12
BYTES
(When
length is
1, length
BYTE =
0)
<FO>
First Octet.
Bit/s
Reference
Description
0-1
Message-
Type-
Indicator
Parameter
describing the
message type.
1 0 SMS-
COMMAND (in
the direction
MS to SC)
1 BYTE