Telit Wireless Solutions LE910C series - AT#BDISCONNECT - BLE Disconnect

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1834 of 1904 2022-03-04
Not Subject to NDA
3.35.3. AT#BDISCONNECT - BLE Disconnect
This command is used to disconnect the existing Bluetooth connection.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#BDISCONNECT=<CONNECTION HANDLE>
Set command is used to disconnect the existing Bluetooth connection
addressed by the connection handle, from the corresponding BCONNECT
event.
Parameter:
Name
Type
Default
Description
<CONNECTION
HANDLE>
hex
N/A
It specifies the connection
handle of the connected device.
Value:
0x1÷0xFFFF
:
The supported parameter value
range
Additional info:
Asynchronous Event:
#BDISCONNECT: <Connection Handle>
<Connection Handle> : It specifies the connection disestablishment
with specified handle.
Example:
#BDISCONNECT: 4