Telit Wireless Solutions LE910C series - AT#; - Repeat Last Command

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 113 of 1904 2022-03-04
Not Subject to NDA
3.2.1.3. AT#/ - Repeat Last Command
The command immediately executes the previously issued command or commands.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#/
If AT#/ is issued, the device immediately executes once again the body of
the preceding command line. No editing is possible, and no termination
character is necessary. A command line may be repeated multiple times
through this mechanism, if desired.
If AT#/ is issued before any command line has been executed, the
preceding command line is assumed to have been empty (that results in
an OK result code).
This command is the same as A/ but does not need a fixed +IPR.