Telit Wireless Solutions LE910C series - AT#NITZ - Network Identity and Time Zone

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 711 of 1904 2022-03-04
Not Subject to NDA
3.7.12. AT#NITZ - Network Identity and Time Zone
This command handles Network Identity and Time Zone.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT#NITZ=[<val>[,<mode>]]
Set command enables/disables the automatic date/time updating and the
Full Network Name applying. It enables also the #NITZ URC in the format:
#NITZ: <datetime>
and permits to change its format.
Parameters:
Name
Type
Default
Description
<val>
integer
7
identifies the functionalities to enable.
The <val> parameter is a sum of integer
values, where every value corresponds to a
functionality:
1 - enables automatic date/time updating
2 - enables Full Network Name applying
4 - sets the #NITZ URC 'extended' format
(see <datetime> below)
8 - sets the #NITZ URC 'extended' format
with Daylight Saving Time (DST) support
(see <datetime> below)
Values:
0
:
disables every functionality
1÷15
:
sum of integer values