Telit Wireless Solutions LE910C series - AT+CMGS - Send Short Message

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 642 of 1904 2022-03-04
Not Subject to NDA
3.6.16. AT+CMGS - Send Short Message
The command is related to sending short messages.
3GPP TS 27.005
3GPP TS 23.040
3GPP TS 23.038
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT+CMGS
Execution command sends a short message to the network. It can have
two syntax formats according to the SMS format: PDU or Text mode (see
+CMGF command). If short message is successfully sent to the network,
the result is shown with the following URC:
+CMGS: <mr>[,<scts>]
Additional info:
In PDU mode, the +CMGS command has the following syntax:
AT+CMGS=<length>
After command line is terminated with <CR>, the module responds
sending a four-character sequence prompt:
<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)
and waits for the specified number of bytes. the PDU shall be
hexadecimal format (each octet of the PDU is given as two IRA
character long hexadecimal number) and given in one line.