Telit Wireless Solutions LE910C series - AT+CLIP - Calling Line Identification Presentation

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 518 of 1904 2022-03-04
Not Subject to NDA
3.4.52. AT+CLIP - Calling Line Identification Presentation
This command enables/disables the presentation of the CLI (Calling Line Identity).
3GPP TS 27.007
3GPP TS 22.081
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Specific profile
No
-
2
AT+CLIP=[<enable>]
Set command refers to the supplementary service CLIP (Calling
Line Identification Presentation) that enables a called subscriber to get
the calling line identity (CLI) of the calling party when receiving a mobile
terminated call. If enabled the device reports after each RING the
response:
+CLIP: <number>,<type>,"",128,<alpha>,<CLI_validity>
Parameter:
Name
Type
Default
Description
<enable>
integer
0
enables/disables CLI indication. The
command changes only the report
behavior of the device, it does not change
CLI supplementary service setting on the
network.
Values:
0
:
disable
1
:
enable
Unsolicited fields: