Telit Wireless Solutions LE910C series - AT$GPSDPO - Dynamic Power Optimization Control

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1722 of 1904 2022-03-04
Not Subject to NDA
3.28.3.2. AT$GPSDPO - Dynamic Power Optimization Control
This command configures the Dynamic Power Optimization (DPO) Control.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT$GPSDPO=<enable>
Set command configures the Dynamic Power Optimization (DPO) Control.
Parameter:
Name
Type
Default
Description
<enable>
integer
0
DPO mode
Values:
0
:
DPO shall be disabled
1
:
DPO shall be enabled with dynamic duty cycle
2
:
DPO shall be enabled only if device is not connected
to an external power source (not running on battery)
AT$GPSDPO?
Read command returns the currently setting, in the format:
$GPSDPO: <enable>
AT$GPSDPO=?
Test command reports the range of supported values for parameter
<enable>.