Telit Wireless Solutions LE910C series - Call (Voice and Data) Control; ATD - Dialup Connection

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 331 of 1904 2022-03-04
Not Subject to NDA
3.2.5. Call (Voice and Data) Control
3.2.5.1. ATD - Dialup Connection
This command establishes a Mobile Originated call to the destination phone number.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
Yes
-
2
ATD
The ATD execution command can assume different formats, which are
described in the following Additional info section.
Additional info:
ATD<number>[;]
If ";" character is present, a voice call is performed using the phone
number given as parameter.
Name
Type
Default
Description
<number>
string
-
phone number to be dialed
Accepted characters are 0-9
and *,#,"A", "B", "C", "+". For
backwards compatibility with
landline modems, modifiers "R",
",", "W", "!", "@" are accepted,
but have no effect. "P" will pause