Telit Wireless Solutions LE910C series - AT#ENSSHD - Enable;Disable the SSHD Daemon

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 181 of 1904 2022-03-04
Not Subject to NDA
3.2.2.44. AT#ENSSHD - Enable/disable the SSHD daemon
This command is used to enable/disable the SSHD daemon.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ENSSHD=<mode>
Set Command to enable/disable the SSHD daemon.
Parameter:
Name
Type
Default
Description
<mode>
integer
0
SSHD daemon mode
Values:
0
:
disable SSHD daemon
1
:
enable SSHD daemon
NOTE: If the USB composition is not RNDIS(ECM), the SSHD
daemon will not run.
NOTE: Rebooting with SSHD enabled will increase boot time by
5~10 seconds
AT#ENSSHD?
Read command returns the current operation in the following format:
# ENSSHD: <operation>
...
OK